Many customers didn't come into contact with hot melt marking machine construction have such misunderstanding, thought cold spraying, hot melt marking machine and room temperature as long as there is a construction can be carried out on a hot melt marking machine. But the reality is, hot melt marking machine construction is much more complicated than normal temperature line construction.
1. Because of the hot melt marking machine construction, the powder coating of hot melt marking machine must be heated to 180-200 ℃ high temperature melts into liquid to use. In order to ensure construction safety, small hot melt marking machine when used alone, should be crossed and hot melt coating heating equipment used separately, avoiding the unnecessary scald, still can greatly improve the efficiency of melting at the same time.
2. In the first line construction team, need to use the hot melt marking machine are: hydraulic double-cylinder hot melt marking machine, senior LXD860 hand push type marking machine, hand push type marking machine, etc. Among them: hydraulic double cylinder type hot melt kettle is recommended to use hydraulic double cylinder hot melt kettle. The utility model adopts the vehicular hot kettle, transportation is convenient.
3. At the same time, the melt with high efficiency, good quality of the melt, less fuel use, energy conservation, environmental protection, simple, safe and reliable operation etc., with hand push marking machine, used for yellow, white, hot melt marking and take a short virtual line construction is very efficient.
In the construction of the ruling machine for surface cleaning: special arrange personnel to clean the road, to ensure that the surface cleaning, no dust. (2) measuring lofting: under the condition of the surface cleaning, according to the dot design, and then select the white latex material will curb line out, check and correct marking after delimit. (3) marker lines delimit:
A: to add hot melt coating hot melt in cavity, uniform heating to the right temperature
B: place good water side, designed for under the road surface coated with uniform coating agent, the pavement and the line stick better, and can isolate the underground water, avoid the construction after the end of line loss.
C: hand push construction vehicles, will melt into the conditions for the construction of hot melt coating in the car, the car put a moderate amount of glass bead in the bucket. Adjust the flow velocity, when the bottom oil after drying to the right degree, an official construction. With water as the base, to ensure construction quality.
D: drive line, lane boundary, guide arrow, road centerline, warning signs, such as coating thickness as follows: 1.5-2.0 mm, deceleration sign thickness 5 mm. Surface of glass beads with cloth should be uniform, draw lines should be has good visual sex, width, spacing, flush, reflective effect is good, combined with the road firmly. Cleaning: construction, when construction, crossed to clean, do not throw, sprinkling, drop, leakage, no pollution, no oil leaking in the equipment leakage phenomenon. Construction team, a certain distance in a timely manner to clean up the pavement marking, keep the road clean, don't cause pollution.